Anycubic Vyper - thoughts?

[MavericK]

I've been looking into getting a ~$300 beginner 3D printer, and I was looking pretty extensively at the Creality Ender 3 V2, but recently I saw a review on the Anycubic Vyper that said it was basically an Ender 3 V2 but with all of the upgrades that you would normally do. The price difference between them is not terribly great - does anyone have any experience with this printer? It sounds like a good one for a beginner, with auto-levelling, the magnetic spring steel plate, etc.

 

[modi123]

I would put the Anycubic Vyper on part with the new Ender3 - S1.
https://www.creality3dofficial.com/products/ender-3-s1-direct-drive-3d-printer

Looks like a decent printer and a step beyond the Ender3V2.

 

[MavericK]

I would put the Anycubic Vyper on part with the new Ender3 - S1.
https://www.creality3dofficial.com/products/ender-3-s1-direct-drive-3d-printer

Looks like a decent printer and a step beyond the Ender3V2.

Thanks, I wasn't aware of the S1. Price is similar, though I think you can get the Vyper a bit cheaper.

 

[Madwheelie]

I have an Anycubic Kobra which I think is similar to the Vyper. So far it has been a solid printer, had to replace the board cooling fan as it started sounding awful (customer service sent me a new one). Prints come out nice one you have settings dialed in, but that is something all printers will need.