• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

Recent content by ocphangaz

  1. O

    Air Duct no more!

    wow... what a nostalgic thread... after 6 years the PC is still running strong with 24/7 OC at 3.0Ghz.. gone through 2 graphic cards X800XT and also now running on 7900GS... damn i'm olskool.. this mod has kept my pc running stable all these years. the mesh is doing it's job and i have 2...
  2. O

    My Last benchies

    This is my LAST OC before i do my volt mod and change my AGP card.. :( Testbed: running ATItool to fully OC my Powercolor 9700-nonPRO (flashed and OCed) OC my cpu to 3.6GHz (need volt mod to fully tap my Mushkin Level2 Special Edition@2226 (heard it was BH6) Whole system is about...
  3. O

    Spray Bombing Camo

    first spray your base colour for camo... greem or muddy brown... then masking tape is your friend! ;)
  4. O

    p4 2.4 oc?

    that means you're using P4 2.4Ghz with 533FSB? these are not so OC-able Also you're indicating you're running 3 DDR? are you running at single channel mode?
  5. O

    Painting fans

    on an unbalanced fan, silent is the least of your worries.. on high RPM fans they can break off and destroy your components in your PC
  6. O

    Computer repair store says i have wrong type of memory. haha :(

    quite true... i can't go to ratio 3:2 with my kingston hynix BT D43 rams.. but with my mushkin PC3200SE it's not a problem
  7. O

    Mixing Memory In My P4 System (Need A Quick Answer Please)

    all i know is that my Kingston Hynix BT D43 not compatible with my Mushkin Special Edition BH 6... they can post, but cannot load into windows even with the latency set to favor the Kingston
  8. O

    Painting fans

    sand the fan a bit so that the paint can stick better... also use very thin layer of paint as thick and uneven paints can cause the fan blades to be unbalanced, and won't want that to happen
  9. O

    Major heat problems :(

    you need bigger fans... my system runs at 45C on load on my delta 92mm 110cfm fan at full speed but it'll climb to 55C if i set it at lower speed by using 7V mod ambient temp is normally 32C with casing temp about 35C
  10. O

    Major heat problems :(

    i won't expect much from a 29CFM fan but is it me or the core speed and multiplier doubled when on load?? further more the core voltage jumps from 1.056v to 1.392v... you're saying on OC or on load? so far from what i've seen, the temp is consistent with the cpu OC
  11. O

    Thermal compound problems...

    stock HSF don't come with pre installed AS5
  12. O

    Trick to sleeving cables?

    you can use a lighter to burn a bit of the loose ends.. not too much... just enough to hold the ends together and still able to stretch
  13. O

    Power for case fan?

    depends on the power rating... if it pulls more than 0.5A at 12V, then it is better at psu
  14. O

    Computer issue....

    is your CPU fan running? how about dusts?
  15. O

    Floppy Bay Cooler?

    you try to mod those PCI exhaust fans to fit in the floppy
See more
Back
Top