• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

Recent content by TCD

  1. T

    Square Power connnector?

    chances are if your PSU doesnt have the 4 square plug I doubt it will run the Neo2 and CPU. These babies like lots of watts and in particular LOTS of amps on the 12v rail. Think 20+
  2. T

    Post your MSI Neo2 Platinum results here

    ok, many people have been able to run ballistix PC4000 stable on the Neo2s. I ran prime95 on my neo2 3500+ for over 2 hours before I stopped the test. So, my pc4000 runs fine 2-3-3-10 1T @ 210FSB
  3. T

    Need help with MSI K8N Neo2 Platinum case cable connections

    Well you found it didnt you? It was pretty clear to me as I read the manual page by page, and whalla, there it is 2-19 according to mine, I don't see what's vague about it at all
  4. T

    SATA issue with MSI K8N Neo2 Platinum

    again its part of the driver set Dont worry about it
  5. T

    Need help with MSI K8N Neo2 Platinum case cable connections

    yeah, its in the manuel That's how I hooked mine up
  6. T

    SATA issue with MSI K8N Neo2 Platinum

    I think its part of the nforce drivers dont worry about it
  7. T

    Post your MSI Neo2 Platinum results here

    my pc4000 ballistix is definatly a no go at 2-2-2-10 1T @ 210 2-3-3-10 1T seems fine oh well
  8. T

    I need Firmware Dell 2001fp

    I had a similar problem with my 6800 ultra and 2001FP but when I switched DVI ports(the one closest to the screw/furthest away from the mobo) everything was fine
  9. T

    Post your MSI Neo2 Platinum results here

    lol... crapped out at defualt speeds? I know this is a dumb question, but... you running them at 2.8v?
  10. T

    Post your MSI Neo2 Platinum results here

    I had to disable fastwrites as well as flash to the latest vga bios which normalized the 2d/3d clocks on my 6800 ultra with my neo2 otherwise any d3d games were a slide show
  11. T

    Post your MSI Neo2 Platinum results here

    prime95 ran ok on my box with previous mentioned settings
  12. T

    Post your MSI Neo2 Platinum results here

    hmm I'll give prime95 a shot memtest for 30 mins ran fine on my box neo2 pc4000(2X512) ballistix 2-3-3-10 1T @210
  13. T

    Post your MSI Neo2 Platinum results here

    also sata ports 3 and 4 offer better ocing then 1 and 2 supposedly I have my two raptors on 3 and 4 ;)
  14. T

    Post your MSI Neo2 Platinum results here

    not too sure on that... Our memory controllers are similar but not the same... Our cpus support dual channel etc where yours dont, hence upping the pin count
  15. T

    Wheres the damn nForce 3 mobo's????

    Well I went with the Neo2 and am pretty happy with it I hit a temp OC limit around 220 but I havent played around to get over it 210 with 1T is good for right now.....
See more
Back
Top