smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.15.0-53-generic] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Seagate Enterprise Capacity 3.5 HDD Device Model: ST10000NM0016-1TT101 Serial Number: ZA2398Q3 LU WWN Device Id: 5 000c50 0a52c2e73 Firmware Version: SND0 User Capacity: 10,000,831,348,736 bytes [10.0 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 7200 rpm Form Factor: 3.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ACS-3 T13/2161-D revision 5 SATA Version is: SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Thu Dec 1 23:45:42 2022 EST SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 567) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 888) minutes. Conveyance self-test routine recommended polling time: ( 2) minutes. SCT capabilities: (0x50bd) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 10 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000f 079 063 044 Pre-fail Always - 79826560 3 Spin_Up_Time 0x0003 092 091 000 Pre-fail Always - 0 4 Start_Stop_Count 0x0032 100 100 020 Old_age Always - 131 5 Reallocated_Sector_Ct 0x0033 100 100 010 Pre-fail Always - 8 7 Seek_Error_Rate 0x000f 087 060 045 Pre-fail Always - 472627708 9 Power_On_Hours 0x0032 054 054 000 Old_age Always - 40606 (152 159 0) 10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 131 184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0 187 Reported_Uncorrect 0x0032 001 001 000 Old_age Always - 100 188 Command_Timeout 0x0032 100 100 000 Old_age Always - 0 0 0 189 High_Fly_Writes 0x003a 001 001 000 Old_age Always - 164 190 Airflow_Temperature_Cel 0x0022 079 051 040 Old_age Always - 21 (Min/Max 19/21) 191 G-Sense_Error_Rate 0x0032 096 096 000 Old_age Always - 8512 192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 588 193 Load_Cycle_Count 0x0032 099 099 000 Old_age Always - 2452 194 Temperature_Celsius 0x0022 021 049 000 Old_age Always - 21 (0 16 0 0 0) 195 Hardware_ECC_Recovered 0x001a 009 001 000 Old_age Always - 79826560 197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0 240 Head_Flying_Hours 0x0000 100 253 000 Old_age Offline - 40069h+55m+55.472s 241 Total_LBAs_Written 0x0000 100 253 000 Old_age Offline - 194622694219 242 Total_LBAs_Read 0x0000 100 253 000 Old_age Offline - 1037574986892 SMART Error Log Version: 1 ATA Error Count: 103 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 103 occurred at disk power-on lifetime: 32108 hours (1337 days + 20 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 53 00 d8 0b 00 00 Error: UNC at LBA = 0x00000bd8 = 3032 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 00 ff ff ff 4f 00 00:06:42.288 READ FPDMA QUEUED 60 00 00 ff ff ff 4f 00 00:06:42.287 READ FPDMA QUEUED 60 00 00 00 0b 00 40 00 00:06:42.287 READ FPDMA QUEUED 60 00 b0 50 09 00 40 00 00:06:42.287 READ FPDMA QUEUED 60 00 08 48 09 00 40 00 00:06:42.277 READ FPDMA QUEUED Error 102 occurred at disk power-on lifetime: 32108 hours (1337 days + 20 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 53 00 d8 0b 00 00 Error: UNC at LBA = 0x00000bd8 = 3032 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 00 ff ff ff 4f 00 00:06:37.014 READ FPDMA QUEUED 60 00 00 ff ff ff 4f 00 00:06:37.014 READ FPDMA QUEUED 60 00 00 00 0b 00 40 00 00:06:37.013 READ FPDMA QUEUED 60 00 b0 50 09 00 40 00 00:06:37.013 READ FPDMA QUEUED 60 00 08 48 09 00 40 00 00:06:37.007 READ FPDMA QUEUED Error 101 occurred at disk power-on lifetime: 32108 hours (1337 days + 20 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 53 00 d8 0b 00 00 Error: UNC at LBA = 0x00000bd8 = 3032 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 00 00 0a 00 40 00 00:06:31.474 READ FPDMA QUEUED 60 00 00 00 0a 00 40 00 00:06:31.474 READ FPDMA QUEUED 60 00 10 10 0a 00 40 00 00:06:31.474 READ FPDMA QUEUED 60 00 10 ff ff ff 4f 00 00:06:31.473 READ FPDMA QUEUED 2f 00 01 10 00 00 00 00 00:06:31.339 READ LOG EXT Error 100 occurred at disk power-on lifetime: 32108 hours (1337 days + 20 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 53 00 d8 0b 00 00 Error: UNC at LBA = 0x00000bd8 = 3032 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 10 ff ff ff 4f 00 00:06:28.775 READ FPDMA QUEUED 60 00 10 10 0a 00 40 00 00:06:28.775 READ FPDMA QUEUED 60 00 00 00 0a 00 40 00 00:06:28.774 READ FPDMA QUEUED 60 00 00 00 0a 00 40 00 00:06:28.774 READ FPDMA QUEUED 2f 00 01 10 00 00 00 00 00:06:28.721 READ LOG EXT Error 99 occurred at disk power-on lifetime: 32108 hours (1337 days + 20 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 53 00 d8 0b 00 00 Error: UNC at LBA = 0x00000bd8 = 3032 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 10 10 0a 00 40 00 00:06:26.175 READ FPDMA QUEUED 60 00 00 00 0a 00 40 00 00:06:26.175 READ FPDMA QUEUED 60 00 10 ff ff ff 4f 00 00:06:26.175 READ FPDMA QUEUED 60 00 10 ff ff ff 4f 00 00:06:26.174 READ FPDMA QUEUED 60 00 00 00 0a 00 40 00 00:06:26.174 READ FPDMA QUEUED SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Conveyance offline Completed without error 00% 40486 - # 2 Short offline Completed without error 00% 40486 - # 3 Conveyance offline Completed without error 00% 0 - # 4 Short offline Completed without error 00% 0 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.