smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.15.0-53-generic] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Seagate Enterprise Capacity 3.5 HDD Device Model: ST10000NM0016-1TT101 Serial Number: ZA20NAPH LU WWN Device Id: 5 000c50 0a3444220 Firmware Version: SND0 User Capacity: 10,000,831,348,736 bytes [10.0 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 7200 rpm Form Factor: 3.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ACS-3 T13/2161-D revision 5 SATA Version is: SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Thu Dec 1 23:44:39 2022 EST SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 584) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 893) minutes. Conveyance self-test routine recommended polling time: ( 2) minutes. SCT capabilities: (0x50bd) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 10 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000f 076 064 044 Pre-fail Always - 36552163 3 Spin_Up_Time 0x0003 091 091 000 Pre-fail Always - 0 4 Start_Stop_Count 0x0032 100 100 020 Old_age Always - 132 5 Reallocated_Sector_Ct 0x0033 100 100 010 Pre-fail Always - 0 7 Seek_Error_Rate 0x000f 087 060 045 Pre-fail Always - 543192176 9 Power_On_Hours 0x0032 054 054 000 Old_age Always - 41091 (6 217 0) 10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 133 184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0 187 Reported_Uncorrect 0x0032 100 100 000 Old_age Always - 0 188 Command_Timeout 0x0032 100 100 000 Old_age Always - 0 0 0 189 High_Fly_Writes 0x003a 068 068 000 Old_age Always - 32 190 Airflow_Temperature_Cel 0x0022 079 050 040 Old_age Always - 21 (Min/Max 20/21) 191 G-Sense_Error_Rate 0x0032 094 094 000 Old_age Always - 13229 192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 628 193 Load_Cycle_Count 0x0032 099 099 000 Old_age Always - 2469 194 Temperature_Celsius 0x0022 021 050 000 Old_age Always - 21 (0 13 0 0 0) 195 Hardware_ECC_Recovered 0x001a 009 001 000 Old_age Always - 36552163 197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0 240 Head_Flying_Hours 0x0000 100 253 000 Old_age Offline - 40537h+48m+55.843s 241 Total_LBAs_Written 0x0000 100 253 000 Old_age Offline - 194360728347 242 Total_LBAs_Read 0x0000 100 253 000 Old_age Offline - 1067540945649 SMART Error Log Version: 1 ATA Error Count: 4 CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 4 occurred at disk power-on lifetime: 31383 hours (1307 days + 15 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 04 73 00 00 00 00 00 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- ea 00 00 00 00 00 00 00 19d+10:29:46.581 FLUSH CACHE EXT 61 00 08 ff ff ff 4f 00 19d+10:29:46.577 WRITE FPDMA QUEUED 61 00 08 ff ff ff 4f 00 19d+10:29:46.577 WRITE FPDMA QUEUED 61 00 08 c0 0b 00 40 00 19d+10:29:46.576 WRITE FPDMA QUEUED 61 00 08 c0 09 00 40 00 19d+10:29:46.576 WRITE FPDMA QUEUED Error 3 occurred at disk power-on lifetime: 31383 hours (1307 days + 15 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 04 73 09 82 00 80 40 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- ea 00 00 00 00 00 00 00 19d+10:29:46.581 FLUSH CACHE EXT 61 00 08 ff ff ff 4f 00 19d+10:29:46.577 WRITE FPDMA QUEUED 61 00 08 ff ff ff 4f 00 19d+10:29:46.577 WRITE FPDMA QUEUED 61 00 08 c0 0b 00 40 00 19d+10:29:46.576 WRITE FPDMA QUEUED 61 00 08 c0 09 00 40 00 19d+10:29:46.576 WRITE FPDMA QUEUED Error 2 occurred at disk power-on lifetime: 30913 hours (1288 days + 1 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 04 73 00 00 00 00 00 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- ea 00 00 00 00 00 00 00 1d+14:08:26.763 FLUSH CACHE EXT 61 00 08 ff ff ff 4f 00 1d+14:08:26.755 WRITE FPDMA QUEUED 61 00 08 ff ff ff 4f 00 1d+14:08:26.755 WRITE FPDMA QUEUED 61 00 08 78 0b 00 40 00 1d+14:08:26.755 WRITE FPDMA QUEUED 61 00 08 78 09 00 40 00 1d+14:08:26.755 WRITE FPDMA QUEUED Error 1 occurred at disk power-on lifetime: 30913 hours (1288 days + 1 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 04 73 09 82 00 80 40 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- ea 00 00 00 00 00 00 00 1d+14:08:26.763 FLUSH CACHE EXT 61 00 08 ff ff ff 4f 00 1d+14:08:26.755 WRITE FPDMA QUEUED 61 00 08 ff ff ff 4f 00 1d+14:08:26.755 WRITE FPDMA QUEUED 61 00 08 78 0b 00 40 00 1d+14:08:26.755 WRITE FPDMA QUEUED 61 00 08 78 09 00 40 00 1d+14:08:26.755 WRITE FPDMA QUEUED SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Conveyance offline Completed without error 00% 40971 - # 2 Short offline Completed without error 00% 40971 - # 3 Conveyance offline Completed without error 00% 0 - # 4 Short offline Completed without error 00% 0 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.